Kit tubeless TNT for all rims holes
- Alternative system for the conversion of Tubeless Ready rims
- Allows the covering of the holes in the rim by means of a cap in a special compound to adapt and expand.
- To be used instead of the classic tubeless tape, eliminating the problems caused by necklines or damage due to the tire levers during assembly
- Recommended use up to 4 bar of pressure
- Spines not reusable
- For aluminum rims without insulation in the joint, a small piece of tape must be applied.
- The kit includes: 28 caps (70 diameter 7,5mm, 70 diameter 8mm, 70 diameter 9mm, 70 diameter 9,5 / 10mm), 70 grains, 2 fitting tool
Place the plugs in the spoke holes by hand, then lock in place with a small plastic screw that expands the plug against the edge of the hole.
For this procedure a small spring tool is provided.