Complete kit composed of sticker kit and matching seat cover. The sticker kit includes: radiator shrouds pair, airbox pair, fork protections pair, swing arm pair, front fender and rear fender. The different pieces of the kit cannot be sold separately. Seat cover to substitute the original one. Produced with the best technologies on the market. It fits perfectly with the shapes of the seat, even with higher foams up to almost 2cm. The special reliefs on the central part of this cover were designed with the objective of holding the rider in the acceleration phase allowing him to give an even greater energy for a higher traction. You can customize your seat cover Whoops deciding where to put the non-slip stripes, basing on the different needs of every pilot. A unique livery which reproduces trends, materials and design used by the official teams of the Motocross World Championship.
The sticky graphics for motocross, enduro, motard and trial are created using high-performing and high-quality materials. The used crystall is 0,5mm thick; the sticker is specifically designed for the off-road use and it is combined with a strong and long lasting adhesive. Silk-screen printing realised with resistant and shiny inks. To obtain the best result, the sticker must always be warmed up with a dryer and exposed to a light pressure. Do not use soaps or solvents; just clean up the surface with a dry rag. Seat cover created on the basis of the latest requests of the market using the best non-slip materials, it gives to the rider an excellent control in the driving. Non-slip effect and technical characteristics focused on the off-road use. The cover has a good water resistance but it isn't completely watertight. The thread used for the seams is waterproof and rubbing-resistant. Only the best materials on the market are used to provide a valuable and high quality product.COMPATIBILITY: